What you need
Step by step
- Position the donor car close, but the cars must not touch. Both cars off, keys out.
- Open both hoods and locate the batteries or jump terminals.
- RED cable: clamp to the + (positive) terminal of the DEAD battery first.
- RED cable other end: clamp to the + terminal of the DONOR battery.
- BLACK cable: clamp to the − (negative) terminal of the DONOR battery.
- BLACK cable other end: clamp to the marked ground point on the DEAD car, or to bare metal on the engine block away from the battery. NOT on the dead battery’s − terminal. Cars with start-stop have a designated ground point: use it, or you can wreck the battery sensor.
- Start the donor car and let it run 2–3 minutes at slightly raised idle.
- Start the dead car, cranking no longer than 15 seconds at a time. If it does not start, wait 2 minutes and try again.
- Before removing the cables, switch on the blower or heated rear window in the revived car. It soaks up the voltage spike and protects the electronics.
- Once running: remove cables in REVERSE order (black from chassis, black from donor, red from donor, red from dead car’s +).
- Let the revived car run or drive for at least 30 minutes to recharge.
- The battery is cracked, leaking or smells of rotten eggs: do not jump it.
- The car starts but dies again immediately (likely alternator failure).
- Repeated attempts fail.
Only work on your car when you are safely away from traffic. Your owner manual shows the exact jacking points, fuse layout and fluid specifications for your car.
